NordicTrack APEX6100 NTTL24992 User Manual
Page 7
5. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the floor or carpet
from damage, place a mat under the treadmill.
7
4. Insert two Handrail Bushings (94) into the right Upright
(83). Turn the Handrail Bushings so they fit against the
Upright as shown in the inset drawing.
Insert two Handrail Bolts (96) with Handrail Washers
(95) into the Handrail Bushings (94), the right Upright
(83), and the right Handrail Spacer (92). Lift up the right
Handrail (73) and align the Bolts with the holes in the
Handrail. Next, thread the Bolts into the Handrail. Do
not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Tighten all four Handrail Bolts (96).
4
96
95
94
83
73
92
94
95
If you purchase the optional chest pulse sensor (see
page 24), follow the steps below to install the receiver
included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. Remove
the indicated Screws from the Console Back (120).
Imortant: The Screws may be different lengths. Keep
track of which Screws were removed from which holes.
2. See drawing 2a. Peel the paper off the pad on the bottom
of the Receiver (A). Turn the Receiver so the cylinder
is on the side shown, and press the Receiver into the
bottom of the Console Base (79) in the indicated location.
See drawing 2b. Connect the Short Jumper Wire (B) to
the wire on the Receiver (A). Connect the other end of
the Jumper Wire to the PULSE jack on the back of the
Console (80). Note: The included Long Jumper Wire and
Wire Tie are not needed and can be discarded.
Make sure that no wires are pinched. See step 1 above.
Reattach the Console (120) with the Screws. Note: If the
Screws are not put in the correct locations, the
Console will be damaged.
2b
120
Screws
1
2a
80
80
79
A
B
A
Cylinder
PULSE
Jack