Getting started, Installing the remote control battery, Push in the clip at the side of the battery holder – Neuros Audio MPEG-4 User Manual
Page 11: Pull battery holder out, Push battery holder and snap it in place
Advertising
2.
Getting started
This chapter describes the preliminary steps required to set up the
Recorder 2 and how to make connections before starting to use
the device.
Installing the remote control battery
Follow these instructions to insert the remote control battery:
1. Push in the clip at the side of the battery
holder.
2. Pull battery holder out.
3. Insert the battery as shown, while noting
the correct polarity.
4. Push battery holder and snap it in place.
MPEG-4 Video Recorder_UM_EN.book Page 7 Monday, June 19, 2006 8:22 PM
Advertising