Navini Networks 40-00292-00 - Manual (Page 6)

Navini Networks, Inc. Ripwave Wireless Broadband Access Card User’s Guide
Regulatory Information
This Ripwave Wireless Broadband Access Card has been tested with a typical laptop computer with a
side loading PCMCIA bay. This PC Card must not be co-located or operated in conjunction with any
antenna (other than the one furnished by Navini and included in the package) or transmitter. Use of this
device in any other configuration may exceed the FCC, ETSI, or other regulatory bodies RF Exposure
compliance limit.
If this equipment causes interference to radio or television reception, which can be determined by turning
the equipment off and on, the user should try to correct the interference by one or more of the following
measures:
1) Reorient or relocate the receiving antenna,
2) Increase the separation between the equipment and the receiver,
3) Consult the dealer or an experienced radio technician for additional suggestions.
FCC guidelines stipulate that the antenna should be more than 2.5 cm (1”) from bystanders and 1.0 cm
(0.39”) from the user. When in use, the antenna should be pointed vertically upward. When using the
Desktop Antenna with the PC Card, a minimum distance of 20 centimeters (8 inches) is required from
the user or bystander.
This product conforms with the Australian Standard for Human Exposure to Radiation at a distance of
2.5 cm. Closer contact, such as touching the aerial will result in radiation in excess of safe limits.
Page 6
060210_pv1.7_Ripwave Wireless Broadband Access Card User’s Guide_40-00292-00d(4.4.2)