Navini Networks 40-00292-00 - Manual (Page 9)

Navini Networks, Inc. Ripwave Wireless Broadband Access Card User’s Guide
Installing Your
Card The following instructions explain how to install the Card and its
driver software on your computer. Please read all instructions
before attempting the installation.
Note: The laptop should be used preferably on a desk when
the Card is installed. Using the laptop with the Card close to the
body, such as on the lap, is undesirable.
Note: The screenshots shown in these instructions were taken
from a laptop operating with Windows 2000. If you have a
Windows 98, XP, or ME operating system, the screens you see
may vary from the screens shown in the instructions.
Step Action
Illustration
1. Insert the Card into the
Type II card slot on your
computer. Be sure to
insert the end that has
the 68-pin connector
into the card slot.
2. Raise the antenna to the
upright position.
3. The Found New
Hardware box appears
indicating the PC sees
the Card.
Windows 2000 Screen
4. The Welcome to the
Found New Hardware
Wizard dialog box
appears. Click Next to
continue. Windows 2000 Screen
Page 9
060210_pv1.7_Ripwave Wireless Broadband Access Card User’s Guide_40-00292-00d(4.4.2)