NETGEAR EVA8000 - Manual (Page 108)

Compliance-2
• This device must accept any interference received, including interference that may cause undesired
operation.
Regulatory Compliance Information
This section includes user requirements for operating this product in accordance with National laws for usage
of radio spectrum and operation of radio devices. Failure of the end-user to comply with the applicable
requirements may result in unlawful operation and adverse action against the end-user by the applicable
National regulatory authority.
NOTE: This product’s firmware limits operation to only the channels allowed in a particular Region or
Country. Therefore, all options described in this user’s guide may not be available in your version of
the product.
FCC Requirements for Operation in the United States
Radio Frequency Interference Warnings and Instructions
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following methods:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Modifications made to the product, unless expressly approved byNETGEAR, Inc., could void the user’s right
to operate the equipment.
Export Restrictions
This product or software contains encryption code that may not be exported or transferred from the US or
Canada without an approved US Department of Commerce export license.
Marking by the above symbol indicates compliance with the Essential Requirements of the R&TTE Directive
of the European Union (1999/5/EC). This equipment meets the following conformance standards: EN300 328,
EN301 489-17, EN60950.
This device is a 2.4 GHz low power RF device intended
for home and office use in EU and EFTA member states.
In some EU / EFTA member states some restrictions may
apply. Please contact local spectrum management
authorities for further details before putting this device
into operation.