NordicTrack C 1800i NTL99030 - Manual (Page 7)

5. Insert two Handrail Bolts (78) with Handrail Spacers (77)
into the right Upright (69) and the right Handrail (66). Be
careful not to pinch the wires. Make sure that the
Handrail Spacers are flush against the right Upright, with
the thick sides facing the center of the treadmill, as shown
in the inset drawing. Next, lift the right Handrail (66) slightly
and align the Bolts with the holes in the Handrail. Thread
the Bolts into the Handrail. Do not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Then, tighten all four Handrail Bolts (78).
6. Make sure that all parts are properly tightened before
you use the treadmill. Place a mat beneath the tread-
mill to protect the floor.
78 77
Thick
Side
69
77
4. Cut the plastic tie holding the Upright Wire Harness (98).
Have a second person hold the Handrails (66) near the
Uprights (69). Connect the Upright Wire Harness to the
wires extending from the Console Base (81). The connec-
tors should slide together easily and snap into place.
If they do not, turn one connector and try again. Then,
insert the connectors and the Upright Wire Harness into
the hole in the right Upright. Set the Handrails on the
Uprights, being careful not to pinch the wires.
98
69
81
66
4
66
If you purchase the optional chest pulse sensor (see
page 21), follow the steps below to install the receiver
included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. Remove
the indicated screws from the Console Back (88).
(Important: The screws may be different lengths; note
the original locations of the screws.) Next, remove the
Console Back.
2. Peel the paper off the pad on the bottom of the Receiver
(A). Turn the Receiver so the cylinder is on the side
shown, and press the Receiver into the Console Base (81)
in the indicated location.
88
82
Screws
1
2
81
A
Cylinder
3. Connect the included Short Jumper Wire (B) to the wire on
the Receiver (A). Connect the other end of the Short
Jumper Wire to the PLS2 jack on the underside of the
Console (82). (Note: If there is already a wire in the PLS2
jack, unplug it.) Discard the other wires included with the
receiver. Use the included wire tie to secure the wires, if
needed.
Make sure that no wires are pinched. See step 1.
Reattach the Console (82) with the screws. Important: If
the screws are not in their original locations, the
Console may be damaged.
82
A
B
PLS2
Jack
3
5
7