NETGEAR MBR624GU User Manual
Page 93
3G Broadband Wireless Router MBR624GU User Manual
Advanced Configuration
5-17
v1.0, January 2009
The following figure shows an example of a Repeater Mode configuration.
To set up a repeater with wireless client association:
1. Configure the operating mode of the devices.
•
Configure AP 1 the MBR624GU router in the previous figure) on LAN Segment 1 with
the MAC address of AP 2 and AP 3 in the first two Remote MAC Address fields.
•
Configure AP 2 with the MAC address of AP 1 in the Remote MAC Address field.
•
Configure AP 3 with the MAC address of AP 1 in the Remote MAC Address field.
2. Verify the following for both access points:
•
The APs must be on the same LAN. That is, the LAN IP addresses for the APs must be in
the same subnet.
•
AP devices must use the same SSID, channel, authentication mode, and encryption.
3. Disable the DHCP servers on repeaters AP2 and AP3. AP1 will then be the DHCP server.
4. Verify connectivity across the LANs. A computer on any LAN segment should be able to
connect to the Internet or share files and printers with any other PCs or servers connected to
any of the three WLAN segments.
Figure 5-10
AP 1
PCs
AP 3 in Repeater mode
Wireless PC
associated with
Wireless PC
associated with
Wireless PC
associated with AP 1
AP 2 in Repeater mode
MBR624GU Router is AP 1
(parent in AP Repeater mode)
AP 3
AP2
192.168.0.1