Navigon 13xx - Manual (Page 17)

User’s manual NAVIGON 13xx | 23xx
Switching on the NAVIGON 13xx | 23xx - 17 -
Caution! Do not press the (On/Off) key for longer than 2 seconds! If
you press the key for longer than 10 seconds, a hardware reset will be
carried out.
After a hardware reset you must re-calibrate the touchscreen. The GPS
receiver will also be re-initialised, which can take up to 20 minutes.
(Refer also to "Initialising the GPS receiver" on page 23)
Note:
When you switch on the NAVIGON 13xx | 23xx for the first time,
you will be asked to make the following settings:
• your preferred language for using for the software
• the unit of length for distances
• the time format
Switching the navigation device to standby mode
When you switch the navigation device to standby mode, the next time
it is switched on it will open with the window which was active when
switched off. In standby mode the device still consumes a small amount
of energy however.
►
Press briefly (max. 2 seconds) on the (On/Off) key.
-or-
►
Tap in the N
AVIGATION
window of the navigation software on the
button.
Automatic Standby
You can configure the NAVIGON 13xx | 23xx so that the navigation
device is automatically switched to standby mode.
►
In the N
AVIGATION
window tap on Options > Settings > General >
Automatic Standby.
►
Select after how much time you want the navigation device to be
switched to standby mode (Never, After 10 mins, After 20 mins,
After 30 mins).
►
Select Power Loss in order to switch the device to standby mode
when the external power supply is interrupted.
Switching off the navigation device
When you switch off the navigation device, the next time it is switched
on it will carry out a restart of the navigation software. Your settings and
your saved destinations and routes will be retained.
►
Press for at least 6 seconds on the (On/Off) key.