Nuvo NV-P2100 - Manual (Page 9)

Voltage Trigger
This input is designed for a mono 1/8" plug to accept a
trigger voltage coming in from an external source.
Fig. 4.
Fig. 4
Any voltage ranging from 3 to 30 volts AC or DC will
cause the amplifier to turn on when the POWER MODE
switch (fig. 3C) is in the AC/DC mode.
Unit On
This output provides a constant 12 volts DC when the
amplifier is powered on. This is useful for powering on
external equipment with the P2100 Fig 5.
Fig. 5
Speaker Output
The P2100 provides 100 watts of output power per
channel at 4 ohms. It uses a modular plug that will
accept up to 14 gage, four conductor, speaker wire.
Stranded Four conductor sixteen gage wire is recom-
mended Fig 6.
Fig. 6
The NV-P2100 amplifier is designed to run at a maxi-
mum load of 4 ohms. Prolonged operation at less than
4 ohms could cause the amplifier to overheat and do
damage to its internal components. Overheating the
amplifier due to an excessive load will void the war-
ranty.
9
CONTROL
UNIT
ON
+12VDC
100mA
VOLTAGE
TRIGGER
3-30 VOLTS
AC OR DC
ON/OFF SWITCH
AUDIO AC/DC
POWER
MODE
CONTROL
CONTROL
UNIT
ON
+12VDC
100mA
VOLTAGE
TRIGGER
3-30 VOLTS
AC OR DC
ON/OFF SWITCH
AUDIO AC/DC
POWER
MODE
CONTROL
SPEAKER
OUTPUT POWER
8 OHM: 70W X 2
4 OHM: 100W X 2