Installation, Rear view of unimux-dvi-16hd, Nti unimux series usb kvm switch 6 – Network Technologies 2907 User Manual
Page 10: Figure 3- connect a dvi monitor, Figure 4- connect the device(s), Usb keyboard usb mouse usb type a male connectors
NTI UNIMUX SERIES USB KVM SWITCH
6
INSTALLATION
1. It is not necessary to turn the CPUs or monitors OFF during this installation.
2.
Connect a DVI-to-DVI cable (should have come with the monitor) from a DVI monitor to the “MONTOR” connector on the rear
of the UNIMUX (See Fig. 3 below.)
Figure 3- Connect a DVI monitor
3.
Connect the male USB type A connector on the keyboard cable to either one of the two USB type A female connectors
labeled with the USB symbol ( ) on the rear of the UNIMUX.
4.
Connect the male USB type A connector on the mouse cable to the remaining USB type A female connector labeled with the
USB symbol on the rear of the UNIMUX.
Figure 4- Connect the device(s)
DVI Enabled
Monitor
Mating Face of
DVI Male
Rear View of UNIMUX-DVI-16HD
CPU 1
CPU 2
CPU 3
CPU 4
CPU 5
CPU 6
CPU 7
CPU 8
CPU 9
CPU 10
CPU 11
CPU 12
CPU 13
CPU 14
CPU 15
CPU 16
RS232
250V,2A
MONITOR
NTI
Tel:330-562-7070
Fax:330-562-1999
1275 Danner Dr
Aurora, OH 44202
www.n etworktech inc.com
R
DVI-D-Male
Existing Cable
DDC
1
8
ON
RS232
USB Keyboard
USB
Mouse
USB Type A
Male Connectors
USB Type A Male
USB Type A Female
Rear View of UNIMUX-DVI-16HD
CPU 1
CPU 2
CPU 3
CPU 4
CPU 5
CPU 6
CPU 7
CPU 8
CPU 9
CPU 10
CPU 11
CPU 12
CPU 13
CPU 14
CPU 15
CPU 16
RS232
250V,2A
MONITOR
NTI
Tel:330-562-7070
Fax:330-562-1999
1275 Danner Dr
Au rora, OH 44202
www.networktechinc.com
R
DDC
1
8
ON
RS232