NordicTrack NTBE06901 - Manual (Page 10)

10
24
2
29
15
29
17
17
32
24
23
25
25
23
14. Pull the Cable (25) down in the indicated location,
so there is no slack at the ends of the Cable.
Locate the other Cable (25). Insert the metal-sleeve
end of the Cable into the indicated hole in the
Weight Guide Base (4). Attach the Cable using an
M10 x 75mm Bolt (34), two M10 Flat Washers (37),
two 28mm Spacers (40), and an M10 Nylon Locknut
(29).
Route the ball-end of the Cable (25) through the
bracket on the Center Base (2). Attach a Pulley (24)
inside the bracket using an M10 x 45mm Bolt (32)
and an M10 Nylon Locknut (29).
15. Wrap the upper Cable (25) around a Pulley (24) as
shown. Attach the Pulley and a Cable Trap (23) to
the two Pulley Plates (17) using an M10 x 45mm
Bolt (32) and an M10 Nylon Locknut (29).
Wrap the lower Cable (25) around a Pulley (24) as
shown. Attach the Pulley and a Cable Trap (23) to
the Pulley Plates (17) using an M10 x 45mm Bolt
(32) and an M10 Nylon Locknut (29).
Make sure the Bolts (32) are in the highest and
lowest holes in the Pulley Plates (17). In addition,
make sure the Cables (25) are between the Cable
Traps (23) and the Pulleys (24).
32
34
37
37
40
4
40
25
25
14
16
45
47
47
16. Wet the ends of the Lat Bar (45) with a small
amount of soapy water. Slide the Handgrips (47)
onto the ends of the Lat Bar.
17. Make sure all parts of the weight rack are prop-
erly tightened. In addition, pull each cable a few
times to make sure the cables move smoothly
over the pulleys. If the cables do not move
smoothly, locate and correct the problem. When
weights are used, the cables may be damaged if
they are incorrectly routed.
The use of all remaining parts will be explained in
ADJUSTING THE WEIGHT RACK, beginning on
page 11.