NordicTrack NTBE06901 - Manual (Page 7)

7
3
4a 4b
4. Refer to drawing 4a. Press Square Bushings (21)
into the top and bottom of one of the Weight Rests
(19) and one of the Weight Spotters (20) as shown.
Pull out the Adjustment Knobs (22) and slide the
Weight Spotter and the Weight Rest down over the
right Uprights (7, 8) as indicated.
Refer to drawing 4b. Secure the Weight Spotter
(20) and the Weight Rest (19) to the right Uprights
(7, 8) by snapping each of the three Adjustment
Knobs (22) into one of the adjustment holes in the
Uprights and turning them clockwise until tight.
Assemble the other Weight Spotter (20) and Weight
Rest (19) to the left Uprights (7, 8) in the same
manner. Make sure both Weight Spotters and
both Weight Rests are at the same height.
3
1
31
29
29
21
21
22
22
7
7
8
8
22
22
20
20
19
19
6
6
7
Adjustment
Holes
8
28
3. Attach one of the Front Uprights (7) and two Joint
Plates (6) to the Left Base (3) using four M10 x
78mm Bolts (31) and four M10 Nylon Locknuts (29).
Make sure the Front Upright is oriented so that
the holes on the bottom of the Front Upright
and the holes in the Joint Plates line up. If they
do not line up, turn the Front Upright upside-
down. Do not tighten the Nylon Locknuts yet.
Make sure the Front Upright is turned so the
adjustment holes are facing the Rear Upright
(8).
Attach the other Front Upright (7, not shown) and
two Joint Plates (6, not shown) to the Right Base
(1) in the same manner.
Tap a 60mm Square Inner Cap (28) into the top of
each of the Front Uprights (7).
21
5. Attach the Chin-up Bar (13) and two Joint Plates (6)
to the Front Uprights (7) using four M10 x 78mm
Bolts (31) and four M10 Nylon Locknuts (29). Do
not tighten the Nylon Locknuts yet.
6
29
29
31
31
6
7
13
7
5