Napco Security Technologies XP-400 - Manual (Page 14)

Ambush Code - In the event that
you are forced by an intruder to dis-
arm your system, this special code
can be used to disarm the system,
and simultaneously send a silent
alarm to Central Station. If your sys-
tem has the Ambush feature enabled,
the code assigned as the User 4 code
will function as your Ambush Code
Arming / Disarming - Turning the
system on or off by entering your user
code at the keypad.
Auto Interior Bypass - A feature
which allows the system to recognize
when you have not left the premises
and automatically bypass any interior
zones, deactivating devices such as
motion sensors, allowing free move-
ment throughout the premises.
Battery - A backup source of power
to provide protection for a limited time
in the event of a power failure.
Bypass - the manual or automatic
removal of one or more protection
zones from the system. Press 
and then the zone number to bypass a
zone.
Central Station - Monitors alarm,
emergency and trouble reports from the
alarm system and notifies proper author-
ities.
Chime - a keypad beep which indi-
cates that a door has been opened while
the system is disarmed.
Easy Exit - Allows an occupant to
leave the premises without disarming
the system. Pressing
 and then
 while the system is armed will
permit exit by removing the protection
on the Exit/Entry door for 3 minutes,
Exit/Entry Delay - The amount of
time you are allowed to enter and leave
the premises when the system is armed.
Exit/Entry Zone - A zone which will
allow you to enter and leave the
premises when the system is armed.
Instant Protection - Arming without
Entry Delay while remaining on the
premises.(Press  while armed)
Keypad Sounder - A local warning
device at the keypad to alert that Entry
delay has started,
System Trouble - A problem has
been detected in the system which
may prevent it from working prop-
erly.
' ' SYSTEM light will be lit.
User Code - A four digit code which
is used to arm and disarm the system
from the keypad.
User 1 Code - A four digit code
which can be used to program, re-
program and erase user codes, as
well as arm and disarm the system
from the keypad.
Zone - An area which is protected by
a security device. Your front door may
be designated as Zone 1, while the
living room motion detector may be
Zone 2. Refer to the Zone Label on
your keypad for the Zone Identification
of your system.
Glossary
14
Oi220a
page 14 Tuesday, September 16, 1997 08:30