NordicTrack NETL15520 - Manual (Page 9)

9
• The CR2032 battery may need to be replaced.
Follow the steps below to replace the battery.
Locate the battery
cover on the back of
the sensor unit. Insert a
coin into the slot in the
cover and turn the
cover counterclockwise
to the “open” position.
Remove the cover.
Next, remove the old
battery from the sensor
unit. Insert a new CR
2032 battery, making
sure that the writing is
on top. In addition, make
sure that the rubber gas-
ket is in place in the
sensor unit. Replace the
battery cover and turn it
to the closed position.
CR2032
Battery
Rubber
Gasket
Battery Cover
OPERATION AND ADJUSTMENT
THE PERFORMANT LUBE TM WALKING BELT
Your treadmill features a walking belt coated with PERFORMANT LUBE TM , a high-performance lubricant. IMPOR-
TANT: Never apply silicone spray or other substances to the walking belt or the walking platform. Such
substances will deteriorate the walking belt and cause excessive wear.
HOW TO PLUG IN THE POWER CORD
This product must be earthed. If it should malfunction or break
down, earthing provides a path of least resistance for electric
current to reduce the risk of electric shock. This product is equipped
with a cord having an equipment-earthing conductor and an earth-
ing plug.
Two power cords are included. Select the one that will fit your
outlet. Refer to drawing 1, and plug the indicated end of the
power cord into the socket on the treadmill. Next, lift the indi-
cated tab on the ferrite box and clamp the ferrite box around
the power cord. The ferrite box should not be allowed to slide
along the power cord. Fasten the included plastic tie just be-
hind the ferrite box and cut off the excess plastic tie. Refer to
drawing 2. Plug the power cord into an appropriate outlet that
is properly installed and earthed in accordance with all local
codes and ordinances. Note: In Italy, an adaptor (not included)
must be used between the power cord and the outlet.
Important: The treadmill is not compatible with GFCI-equipped
outlets.
If the power cord is damaged, it must be replaced with a manufac-
turer-recommended power cord.
DANGER:
Improper connection of the
equipment-earthing conductor can result in an in-
creased risk of electric shock. Check with a qualified
electrician or serviceman if you are in doubt as to
whether the product is properly earthed. Do not mod-
ify the plug provided with the product—if it will not fit
the outlet, have a proper outlet installed by a qualified
electrician.
1
2
Socket on treadmill
Outlet
Tab
Ferrite Box
Plastic
Tie