Niles Audio Personal Emergency Reporting System PERS-2400B - Manual (Page 3)

1
1. FRONT PANEL FEATURES
3. CONSOLE BOTTOM FEATURES
2. REMOVING BOTTOM COVER
4. OPTIONAL VB-4B VOICE BOARD INSTALLATION
EMERGENCY BUTTON
• PRESS AND HOLD TO TRIGGER
THE EMEREGNCY ZONE
• PRESS DURING RING FOR
SPEAKERPHONE MODE
• PRESS DURING SPEAKERPHONE
MODE TO DISCONNECT
POWER INDICATOR
TROUBLE INDICATOR
SENDING INDICATOR
HOME INDICATOR
• LIGHTS WHEN AC IS PRESENT
• BLINKS SLOWLY WHEN BATTERY IS CHARGING
• BLINKS QUICKLY WHEN AC IS ABSENT
(CONSOLE ON BATTERY POWER)
• OFF IN TEST AND SETUP MODES
• NORMALLY OFF
• LIGHTS WHEN ANY TRANSMITTERS ARE MISSING
(SUPERVISORY)
• BLINKS SLOWLY WHEN ANY TRANSMITTERS
HAVE A LOW BATTERY
• NORMALLY OFF
• FLASHES WHEN CONSOLE IS PLACING A CALL
• LIGHTS WHEN ACTIVITY TIMER IS ON
• BLINKS SLOWLY WHEN LESS THAN 15 MINUTES
REMAIN ON THE ACTIVITY TIMER
• BLINKS QUICKLY WHEN THE ACTIVITY TIMER HAS EXPIRED
CLEAR BUTTON
HOME BUTTON
• STOPS ALARM
• ADDS CANCEL TO AN ALARM
REPORT IN PROGRESS
• PRESS IMMEDIATELY AFTER
EMERGENCY TO PREVENT REPORT
• CLEARS INDICATORS
• STOPS TROUBLE BEEPER
• PRESS FOR 5
SECONDS TO ADD
A TRANSMITTER
• PRESS TO RESET ACTIVITY TIMER
• PRESS FOR 5 SECONDS TO TURN ACTIVITY TIMER OFF
• IF ACTIVITY TIMER IS OFF, PRESS FOR
5 SECONDS TO TURN ACTIVITY TIMER ON
HOME BUTTON COVER
• ADHESIVE BACKED PLATE TO
HIDE THE HOME BUTTON IF THE
ACTIVITY TIMER IS NOT USED
16 VAC 1.25 AMP
PLUG-IN
TRANSFORMER
EXTERNAL SPEAKER,
RELAY OUTPUT, AND
DIALER POWER
TERMINALS
LOCAL
PHONE
JACK
TELEPHONE
LINE JACK
12-VOLT 1.2 AMP/HOUR
BACKUP BATTERY
POWER
SWITCH
1 AMP 2AG
BATTERY FUSE
(HIDDEN)
TEST
BUTTON
OPTIONAL
VB-4B VOICE BOARD
TO ACCESS THE INSIDE OF THE CONSOLE
PRESS THE TWO LOCKING TABS IN AND
REMOVE THE CONSOLE'S BOTTOM COVER
PRESS
TABS
IN
REMOVE
COVER
CONNECT BLACK
MICROPHONE WIRE
TO CENTER
TERMINAL
CONNECT RED
MICROPHONE WIRE
TO THIS TERMINAL
1 2
3 4
5
PRESS-FIT MICROPHONE INTO
ROUND MOUNTING HOLE
SEAT
MICROPHONE
CAREFULLY ALIGN
PINS TO CONNECTORS
ON BOTH ENDS OF BOARD
NOTE: POWER MUST
BE OFF AND BATTERY
SHOULD BE REMOVED
OR DISCONNECTED
BEFORE INSTALLING
THE AUDIO BOARD
BE SURE THAT THE
WHITE ARROWS ON
AUDIO BOARD POINT
TOWARD THE
BATTERY AREA
PRESS BOARD
COMPLETELY
INTO CONNECTORS
NOTE: AFTER THE AUDIO BOARD
IS INSTALLED AND ENABLED, THE
CONSOLE WILL SPEAK INSTEAD
OF BEEP DURING PROGRAMMING