Nortel Networks Accelar 1050 - Manual (Page 36)

36
Chapter 2 Installing option cards in the Nortel VPN Router 1100
NN46110-313 02.01
To install a new LAN, WAN, or serial option card:
1 Use the Web GUI or the command line interface to shut down the gateway.
• Web GUI: Choose Admin > Shutdown. Select the option to power off the
gateway after shutdown.
• Command line interface: Use the reload command to shut down the
system. For example, enter reload power-off disable-logins
“Upgrade hardware” (for the complete syntax of the reload
command, see Nortel VPN Router Using the Command Line Interface.
2 Wait for the system to shut down.
3 Turn off the VPN Router 1100 power.
The power switch and power outlet are on the rear of the VPN Router 1100.
4 Disconnect the power cord from the power outlet and then disconnect the cord
from the VPN Router 1100.
5 Remove the cables attached to the ports of the VPN Router 1100.
6 If there are option cards currently installed, unscrew the two screws on each
bracket and remove the bracket.
2 The VPN Router 1100 must be running Version 5.05.330, 6.05.140 and later,
7.00.062, 7.05.100 and later, or 7.05.300 and later. The VPN Router 1100 supports
10/100 Mbps operation only.
3 The VPN Router 1100 must be running Version 5.0 or later.
4 The VPN Router 1100 must be running Version 4.90 or later.
5 The VPN Router 1100 must be running Version 4.80 or later.
6 The VPN Router 1100 must be running Version 4.80 or later.
7 The VPN Router 1100 must be running Version 4.80 or later.
Warning: Risk of electric shock
Make sure to turn off the VPN Router 1100 and unplug it before you
attempt to remove or install an option card.
Caution:
Risk of equipment damage
Unscrew the option card brackets before you remove the cover from the
VPN Router 1100, or you will damage the option cards.