NEC 2000 Series - Manual (Page 61)

3-28 Configuring the System
5. When the menu asks you to enter a path/filename, use the arrow keys
to select the “.bio” file and press
Enter .
6. The utility asks for confirmation to load the new flash into memory.
Select
Continue with Programming .
7. After the upgrade completes, remove the diskette.
8. Reboot the system and start the Setup program. Press F9 to reset the
BIOS defaults. Use the recorded Setup selections you made at the
beginning of this procedure to set the parameters.
NEC Application and Driver CD
Use the NEC Application and Driver CD to install any or all of the NECC
provided software, including
T applications
T utilities and device drivers
T NEC INFO Center (online documentation).
Should a problem occur that causes data loss or corruption of
NECC-provided software, you can restore the software to your system
using NEC Application and Driver CD.
Install the software from the NEC Application and Driver CD as follows.
1. Power on your system.
2. Insert the auto-start Application and Driver CD into the CD-ROM
drive. The Selective Restore screen appears, prompting you to select
an application or driver from the list.
3. Click on an application, driver, or utility in the
“Applications/Drivers:” window.
4. Read the information given in the “Important Setup Information:”
window.
5. Click Install to install your selection. Follow any on-screen
instructions to install your selection.