Nokia 230 T - Manual (Page 9)

GB 9
Press once to turn the sound off/on (mute).
Press and hold for a few seconds to switch the Mediamaster
in and out of standby mode.
0 - 9 Change channel and to select individual menu options.
Note: If 0 is entered as the first digit, the TV Release func-
tionality is activated (see below).
0 To toggle between the 230 T and any equipment connected
to the AUX Scart; e. g. a Video recorder or a satellite receiver.
info In viewing mode: To display short and extended information
(if transmitted) about current and next programmes.
In Navi Bars with a bookmark in focus: Will show informa-
tion about the bookmark.
back Go back one level at a time within menus without storing any
settings.
To toggle between present and previous TV/Radio channel
in viewing mode.
Close the Navi Bars.
select Confirm the selection of a highlighted item.
Open the Navi Bars.
opt Select options in viewing mode.
txt Press to enter teletext (if available).
This section describes how to operate the Mediamaster using the buttons on the remote control.
Some of the functions can also be performed by using the buttons on the front panel.
Remote control
Cursor up
Move up in the menus and
change to the next channel in
viewing mode.
Cursor down
Move down in the menus
and change to the previous
channel in viewing mode.
Cursor left
Move left/change set-
tings in menus.
Decrease the volume
level in viewing mode.
Cursor right
Move right/change settings in
menus.
Increase the volume level in
viewing mode.
The cursor button