Nikon DLP 837 Series User Manual

Page 60

Advertising
background image

60

Appendices

Program ming the Remote Control

Press the side button on the remote control to

1.

change to the correct mode for the product you
want to control. Refer to the table below. Only
one of each device type can be controlled in each

mode.

Mode

Affected Device

CABLE/SAT

Cable Box
DTV Receiver
Satellite Receiver

VCR

VCR

DVR
DVD Player/Recorder

DVD

DVD Player/Recorder
DVR

VCR

AUDIO

A/V Receiver
Audio Amplifier

CD Player

Press and hold

2.

POWER on the remote control for

several seconds until the mode indicator blinks
twice and goes off.

Release the

3.

POWER key.

Enter the first five-digit code listed for your equip-

4.

ment.

The mode indicator blinks twice when you

start to enter the code and then once for each
additional keypress.

The mode indicator blinks twice when you finish

entering a valid code.

If you need to start over or wish to exit pro-

gramming mode, temporarily change to a
different mode using the side button.

Point the remote control at the equipment and

5.

press POWER. If the product has no power on/off
function, press a different key, such as

(PLAY),

(STOP), VOLUME UP, or MUTE.

If the equipment responds, the remote control

is properly programmed.

If the equipment does not respond, repeat

steps 2–4 with the next five-digit code listed for
your equipment.

Once you have found the correct code, write it in

6.

the space below for future reference.

Mode

Device Type

Code

CABLE/SAT

VCR

DVD

AUDIO

IMPORTANT

You may need to reprogram the remote control after

changing the batteries. Record the codes for each

mode in the space provided to make this faster.

Code Verification

To determine the code programmed for any mode:

Set the mode to the one you wish to verify.

1.

Press and hold

2.

POWER on the remote control for

several seconds until the mode indicator blinks twice
and goes off.

Press keys

3.

9 9 0

Press

4.

1 and count the blinks of the power key.

Write down the number of blinks as the first digit of
the code.

Repeat step 4 for the second, third, fourth, and fifth

5.

digits of the code.

Au dio Lock: Universal A/V Receiver
Control

With Audio Lock enabled, the remote control operates
volume and mute on the A/V receiver in all modes set by
the side button. Activate Audio Lock if you normally use
an A/V receiver with your TV and other A/V equipment.

Program

1.

AUDIO mode for your A/V receiver as

described in “Programming the Remote Control” on
this page .

With the remote control in

2.

AUDIO mode, hold POWER

on the remote control for several seconds until the
mode indicator blinks twice and goes off.

Press keys

3.

9 9 3 ENTER

The mode indicator will blink twice to indicate Audio
Lock is active.

To Reset the Remote Control to Operate Volume
and Mute for the TV Speakers

Press and hold

1.

POWER for several seconds until the

mode indicator blinks twice and goes off.

Press keys

2.

9 9 3 VOLUME UP.

The mode indicator will blink four times to indicate
Audio Lock has cleared.

Appendix B: Programming the Remote Control, continued

Advertising
This manual is related to the following products: