Figure 3-7, Introduction screen -9 – NETGEAR XM128U User Manual
Page 25
Getting Started Using FirstGear for the Model XM128U ISDN Digital Modem
Installation
3-9
You have a choice between launching this application automatically during the installation of
FirstGear or running it later from the NETGEAR program group folder. Before you can run the
Wizard, you must perform the following steps:
1.
You must first have an active ISDN line (provided by your local telephone company).
2.
You must connect the Model XM128U modem to your PC and the ISDN line as described
on
in “Installing the Modem.”
3.
Make sure that power has been applied to the modem and the PWR LED is on.
4.
Install the Windows 95/NT drivers as described on
.
If you opted not to launch the Wizard automatically during FirstGear installation, do so now by
double-clicking on the appropriate icon from the NETGEAR program group folder.
The introduction screen opens as shown in
Figure 3-7
.
Figure 3-7.
Introduction screen
Xm128u_bk.fm Page 9 Wednesday, February 4, 1998 4:32 PM