North Star M1108D - Manual (Page 40)

Assembly Instructions
40
Step 1
Remove shipping crate
If there are rubber boots on the axles,
remove and discard them
Slide Wheel onto Axle with Valve Stem
facing out
Slide Outer Bearing onto Axle (outer
bearing may be shipped loose in parts bag
or loose inside wheel)
Outer bearing taper points into log splitter
Slide Wheel Washer onto Axle
Step 2
Thread Axle Nut onto Axle (hand tight)
Back Axle Nut off ¼ turn
Make sure Wheel spins freely
Insert Cotter Pin through hole in Axle
and bend it so Axle Nut cannot come
off
Make sure Wheel spins freely
Tap Dust Cap onto Wheel with a soft
faced mallet
Repeat steps 1 and 2 for the other
Wheel
Step 3
Connect Towbar to Axle/Tank
using (2) Tank Bolts and (2) Tank
nuts (already in place)
Tighten Bolts to 90 lb-ft with a
wrench
Towbar
Axle/Tank
Bolt
Fig 02417
Wheel
Wheel
Washer
Axle Nut
Axle with the
Rubber Boot
removed
Cotter
Pin
Valve Stem Out
Dust Cap
Wheel
Axle Nut
Cotter Pin
Outer
Bearing