NordicTrack NTL14951 - Manual (Page 10)

10
11. Remove the knob from the pin. Make sure that the collar
and the spring are on the pin.
Press the Latch Insert (77) into the left Upright (85) as
shown. Use a rubber mallet if necessary. Insert the pin
through the Latch Insert. Tighten the knob back onto the
pin.
77
Knob
85
Pin
Collar
Spring
12. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 31).
To protect the
floor or carpet from damage, place a mat under the treadmill.
If you purchase the optional chest pulse sensor (see page 27) after the treadmill is assembled, follow the
steps below to install the receiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. Follow
assemble steps 8 to 10 in reverse order (begin with step
10).
2. Lift the left side of the console assembly. Be careful not
to pull any wires. Remove the indicated 3/4” Screw (7)
and the Access Door (95) from the left side of the
Console Back (96).
3. Connect the wire on the receiver (A) to the indicated wire
extending from the Console Back (96). Hold the re-
ceiver so the small cylinder is oriented as shown and
is facing the Console Back. Attach the receiver to the
plastic posts on the Access Door (95) with the two in-
cluded small screws.
4. Make sure that no wires are pinched. Reattach the
Access Door (95) with the 3/4” Screw (7). Discard the
other wires included with the receiver.
5. Repeat assembly steps 8 to 10.
A
96
Small
Cylinder 7
95
Wire
Small
Screws
11