NordicTrack NTL14951 User Manual
Page 8
8
If you have purchased an optional chest pulse sensor,
follow step 6 to install the receiver included with the
chest pulse sensor. If you have not, go to step 7.
6. Place the console assembly face-down.
Be careful not to
scratch the face of the console. Remove the indicated
3/4” Screw (7) and the Access Door (95) from the left side
of the Console Back (96).
Connect the wire on the receiver (A) to the indicated wire
extending from the Console Back (96).
Hold the receiver
so the small cylinder is oriented as shown and is fac-
ing the Console Back. Attach the receiver to the plastic
posts on the Access Door (95) with the two included small
screws.
Make sure that no wires are pinched. Reattach the
Access Door (95) with the 3/4” Screw (7). Discard the
other wires included with the receiver.
A
96
Small
Cylinder
7
95
Wire
Small
Screws
7. Cut the tie securing the wires to the right Upright (85).
Have a second person hold the console assembly near the
Uprights. Connect the Upright Wire Harness (73) and the
Pulse Wire (74) to the wires extending from the console as-
sembly.
The connectors should slide together easily
and snap into place. If they do not, turn one connector
and try again. Insert the connectors into the console as-
sembly. If necessary, remove the right accessory tray (not
shown) from the console assembly.
Connect the Upright Ground Wire (113) to the ground wire
extending from the console assembly. Make sure that the
wires are fully inserted into each other. Insert the ground
wires into the console assembly. Reinsert the right acces-
sory tray (not shown) into the console assembly if neces-
sary.
85
73
Console
Assembly
Ground
Wire
74
113
73
74
5. Cut the tie securing the Pulse Wire (74) to the right
Upright (85). Hold the Pulse Bar Assembly (69) near the
crossbar on the Uprights. Connect the Pulse Wire to the
wire in the Pulse Bar Assembly.
The connectors should
slide together easily and snap into place. If they do
not, turn one connector and try again. Insert the wires
into the crossbar.
Open parts bag B. Attach the Pulse Bar Assembly (69) to
the crossbar on the Uprights (85) with four Pulse Bar Bolts
(127) and Star Washers (67). Start all four Pulse Bar Bolts
before tightening them.
Make sure that no wires are
pinched.
Crossbar
74
127
127
69
85
67
67
74
5
6
7