NorthStar Navigation Explorer 710 VHF - Manual (Page 18)

18 Northtstar Explorer VHF Series: 710US, 710EU Operation and Installation Manual
Section 3 - Radio Setup Menu (RADIO SETUP)
3-1 Radio Setup Menu (RADIO SETUP)
Edit or delete channel names.
See Section 3-2.
Set the volume level of the incoming call notifi cation beeps.
See section 3-3.
Set the volume level of the beeps.
See section 3-3.
Switch ON/OFF (on/off ) the radio’s internal speakers.
See section 3-4.
Selects the operation of Dual or Tri watch scanning.
See section 3-5.
(Selects if the WX Alert scanning mode is ON (on) or OFF (off ). (VHF 710US only.)
See section 3-6.
Select NMEA protocol for communications between the VHF radio and any other
instruments.
See section 3-7.
Sections 1-3 and 1-4 explain how to navigate around the menu and enter, save and change data.
3-2 Channel Names (CH NAME)
The channel charts are listed in Appendix C with their default name tags. CH NAME gives you the option
to edit or delete the channel name tags displayed on the screen.
1. Select RADIO SETUP, then CH NAME.
2. Use + or - to step through the channels with their name tags until you see the channel name tag you
want to change, then press ENT. In this example, the channel name TELEPHONE associated with channel
01 is being changed to PHONE1.
3. Select EDIT and press ENT to edit the existing name tag. Input the new name over the existing name.
It can be a maximum of 12 characters.
To delete the channel name, select DELETE and press ENT.
4. Press ENT (repeatedly if necessary) to display the YES/NO confi rmation.
5. Press ENT to confi rm the new channel name tag or the deletion, then press ESC to return to the menu.
CH NAME
RING VOLUME
BEEP VOLUME
INT SPEAKER
WATCH MODE
WX ALERT
COM PORT
RADIO SETUP
> CH NAME
RING VOLUME
BEEP VOLUME
EDIT CH NAME
TELEPHONE
CH NAME
01
TELEPHONE
SAVE CH NAME
PHONE1
> YES
NO
TELEPHONE
> EDIT
DELETE