NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111 - Manual (Page 2)

For Windows 2000, Me, or 98SE computers
1 1 First, Install the WG111 Software
a. Power on your PC, let the operating system boot up completely, and log in
as needed.
b. Insert the 54 Mbps Wireless USB 2.0 Adapter Resource CD into your CD-ROM
drive. The CD main page shown below will load.
c. Click the Install Driver & Utility link.
d. Follow the InstallShield Wizard steps, click Finish when done, and if prompted,
restart your computer.
2 2 Next, Install the WG111 Wireless Adapter
Note: You should have a USB 2.0 port on your computer. Older USB 1.1 ports will
work but cannot support the higher throughput speeds of the WG111.
a. Insert the WG111 into a USB slot. After a short delay, the Found New
Hardware Wizard displays. Click Next to proceed.
Note: If Windows 2000 displays a
Digital Signature Not Found warning,
click Yes to continue the installation.
*201-10106-01*
2 0 1 - 1 0 1 0 6 - 0 1 February 2004
©2004 NETGEAR, Inc. NETGEAR, the Netgear logo and Everybody's connecting are trademarks or registered
trademarks of Netgear, Inc. in the United States and/or other countries. Microsoft and Windows are registered
trademarks of Microsoft Corporation in the United States and/or other countries. Other brand and product
names are trademarks or registered trademarks of their respective holders. Information is subject to change
without notice. All rights reserved.
b. Follow the Found New Hardware Wizard steps, click Finish when done, and if
prompted, restart your computer.
c. Next, you will be prompted to choose the country where you are located. Select
your location from the list.
d. You will now see the WG111 system tray icon in the lower right area of the
Windows task bar.
3 3 Now, Configure Your WG111 and Save the Profile
a. Open the WG111 Smart Wireless Settings Utility by clicking on the icon in the
Windows system tray.
b. The utility opens to the Settings tab page. Click Help for instructions on using
the Smart Wizard Wireless Utility.
c. Change the Network Name SSID to match your network.
Tip: To view the available wireless networks, use the drop-down list or the
Networks tab and choose the one you want.
d. Click Apply to activate the connection.
Tip: Create work and home profiles. Then, activate whichever one you need for
your current location.
Note: The status bar at the bottom of the utility reports the speed of your
connection. USB 1.1 ports limit the speed of the WG111 to 14 Mbps.
4 4 Finally, Verify Wireless Network Connectivity
a. Verify that the status monitor information at the bottom of the utility matches
your wireless network.
b. Check the color of the WG111 icon in the Windows system tray: green or
yellow indicates a working connection; red indicates no connection.
c. Check the WG111 LED: blinking means attempting to connect; solid indicates
a good connection; off means the WG111 is not plugged in.
d. Verify connectivity to the Internet or network resources.
Note: If you are unable to connect, see troubleshooting tips in the Basic Installation
section of the Reference Manual on the 54 Mbps Wireless USB 2.0 Adapter Resource CD.
Technical Support
PLEASE REFER TO THE SUPPORT INFORMATION CARD THAT SHIPPED
WITH YOUR PRODUCT.
By registering your product at www.NETGEAR.com/register, we can provide you with
faster expert technical support and timely notices of product and software upgrades.
Attention: This device may be used throughout the European
community. Some restrictions may apply in France and Italy.
! 0560