Navini Networks Ripwave - Manual (Page 7)

Navini Networks, Inc. Ripwave MX Modem User Guide
required to comply with FCC RF
LMX Modems except for the 2.6 LMX
20 cm) or more must be
intained between the antenna and all persons during device operations to ensure compliance
th th For the 2.6 LMX Modem with a window
unt, een the window mount
te cannot be maintained,
exposure to RF levels that exceed the FCC’s limits may result.
t
se
d by
different from the one to which the
an for additional suggestions.
This product has been tested and found to be safe in accordance with the Australian Standard for
Human Exposure to Radiation where the user or other parties are 20 cm or more from the aerial.
INFORMATION TO USER
This device has been authorized as a radio frequency transmitter under the appropriate rules of the
Federal Communications Commission. Any changes or modifications not expressly approved by
Navini Networks could void the user’s authority to operate the equipment.
INFORMATION REGARDING ANTENNAS
This device has three embedded antennas: one upright antenna with approximately 2 dBi gain and
two patch antennas, one on each side of the device. Each patch antenna has approximately 6 dBi
gain.
Regulatory Information
FCC Notice
CAUTION: This device is a Radio Frequency transmitter. It is
exposure requirements for transmitting devices. For all
with window mount, a minimum separation distance of 8 inches (
ma
wi
e FCC’s rules for Radio Frequency Exposure.
mo a minimum of 8.3 inches (21 cm) or more must be maintained betw
an ng device operations. If this minimum distance nna and all persons duri
FCC Compliance and Advisory Statemen
Tested To Comply
With FCC Standards
This equipment has been tested and found to comply with the limits for a class B digital device,
Pursuant to Part 15 of the FCC rules. The operation is subject to the following two conditions:
FOR HOME OR OFFICE USE
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cau
undesired operation.
If this equipment causes interference to radio or television reception, which can be determine
turning the equipment off and on, the user should try to correct the interference by one or more of
the following measures:
1)
Reorient or relocate the receiving antenna,
2) Increase the separation between the equipment and the receiver,
3) Connect the equipment to an outlet on a circuit that is
receiver is connected,
4) Consult the dealer or an experienced radio/TV technici
7
060210_pv1.6_Ripwave-MX Modem User Guide_40-00382-00b(4.4.2)