New Balance 1500 - Manual (Page 7)

6
Parts Box
Tools Required: (included)
Allen Wrench
Multi Hex Tool with
Phillips Screwdriver
NOTE: All location references, such as front, rear,
left or right, made in these instructions are from the
user position – on the Treadmill facing the Console.
ASSEMBLY/SETUP INSTRUCTIONS
M8 washer (2)
M8 curved washer (4)
side cap (2)
cup holders (2)
FOR 1500 UNIT ONLY
allen wrench
multi hex tool
with phillips
screwdriver
safety key
M8 x 20mm allen bolt (6)
M4 x 6mm phillips screw (6)
For Maximum Effectiveness and Safety,
Please Read This Owner’s Manual
Before Assembling or Using Your
New Balance 1200/1400/1500 Treadmill.
Fastener Pack
power cord
WARNING
FAILURE TO FOLLOW THIS
PROCEDURE MAY RESULT IN
SERIOUS INJURY.
DO NOT MOVE TREADMILL OUT OF
THE BOX UNTIL UNIT IS ASSEMBLED.
COLLAPSE BOX BOTTOM AND LAY
SIDES DOWN BEFORE ASSEMBLY.
WHEN MOVING ASSEMBLED
TREADMILL OUT OF THE BOX, MOVE
IT OUT OF THE BOX ON ITS WHEELS
WHILE THE DECK IS IN THE FOLDED
AND LOCKED POSITION.
– Console may vary per model –