New Balance 1500 - Manual (Page 9)

8
STEP 3 – Side Cap Assembly
a) Attach Side Cap with (3) M4 x 6mm Phillips
Screws at the bottom of the Upright.
Repeat on other side.
b) Use the Multi Hex Tool with Phillips Screwdriver
provided to tighten.
STEP 4 – Adding Cup Holders to the
Console Base Assembly
Insert Cup Holders into the two holes provided.
Please make sure the taller side of the Cup Holder
is facing away from the Walking Belt.
Figure 3 - Install Side Caps
upright
M4 x 6mm
phillips
screws
side cap
Assembly is now complete.
IMPORTANT:
Follow the “Setting Up Treadmill for
Use” instructions on the next two
pages to move the treadmill off
the shipping carton so you may
begin your workout.
FOR 1500 UNITS ONLY