Assembly – NordicTrack NTL29105.1 User Manual

Page 6

Advertising
background image

6

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.

Assembly can be completed using the included

hex keys.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.

3. Connect the Power Wire Harness (57) in the indicated lo-

cation. Push all of the excess wire up into the right
Upright (95).

Make sure that the Wire Harness is fully

connected.

2. While a second person holds the Handrail (91) near the

Uprights (95, 97), feed the Power Wire Harness (57) in
the right Handrail down into the right Upright. Pull the
end of the Power Wire Harness out of the lower end of
the right Upright. If there is a wire tie on the end of the
Power Wire Harness, remove it. Then, set the Handrail
on the Uprights.

Finger tighten eight Handrail Bolts (99) into the Uprights
(95, 97) and the Handrail (91).

Do not tighten the

Handrail Bolts yet. Be careful to avoid pinching the
Power Wire Harness (57).

Note: The CD Holder (86) and the Cup Holder (85) are
replaceable. If these parts become dislodged from the
Console Base (89), simply press them back in.

1. Slide the Right and Left Uprights (95, 97) onto the brack-

ets near the front of the Frame (76).

Make sure that the

Uprights are on the correct sides; the indicated
holes must be facing inward.

Raise the Right Upright (95) until the lower hole in the
front of the Right Upright is aligned with the upper hole in
the bracket on the Frame (76). Finger tighten an Upright
Bolt (96) into the Right Upright and the bracket.

Do not

tighten the Upright Bolt yet.

Repeat this step with the Left Upright (97).

ASSEMBLY

95

96

76

97

Holes

1

97

91

86

89

85

99

99

99

57

2

95

57

3

95

96

Advertising