NordicTrack NTL29105.1 - Manual (Page 7)

7. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys
for adjustment purposes. To protect the floor or carpet from damage, place a mat under the treadmill.
6. After the treadmill is moved to the location where it will
be used (see HOW TO MOVE THE TREADMILL
below), make sure that both Rear Feet (5) and both
Wheels (not shown) rest firmly on your floor. If the
treadmill rocks slightly on your floor, loosen the Rear
Foot Locknut (113) above the right Rear Foot. Turn the
right Rear Foot clockwise or counterclockwise until the
rocking motion is eliminated. Then, retighten the Rear
Foot Locknut.
5
113
6
5. Plug the indicated end of the Power Cord (48) fully into
the treadmill as shown.
48
5
4. Be careful to avoid pinching your hands or the Power
Wire Harness (not shown) during this step.
While a second person holds the Uprights (95, 97), re-
move the two Upright Bolts (96) used in step 1. Next,
slide the Uprights fully onto the brackets on the Frame
(not shown). Attach each Upright with four Upright Bolts
(96) as shown.
Firmly tighten all eight Upright Bolts.
Firmly tighten the eight Handrail Bolts (99).
HOW TO MOVE THE TREADMILL
Note: It may be helpful to leave the treadmill at an in-
cline while moving the treadmill.
Before moving the
treadmill, make sure that the power cord is un-
plugged from the wall outlet.
Due to the size and weight of the treadmill, moving it
requires two persons. While one person lifts the indi-
cated end, firmly hold the handrails and tip the treadmill
forward until it rolls on the front wheels. Carefully move
the treadmill to the desired location and then lower it.
CAUTION: To reduce the risk of injury, use extreme
caution while moving the treadmill. Do not attempt
to move the treadmill over uneven surfaces.
Lift
Here
Wheels
Handrails
7
5
113
99
99
99
95
96
96
97
4