Nortel Networks Norstar ICS - Manual (Page 9)

7
Speed Dial ≤‚
Dial an external telephone number using a three-digit code.
There are two types of speed dial codes: system (001 to 255)
and user (256 to 279).
System speed dial codes can be used from any display telephone in
the system. They are assigned by your system administrator.
User speed dial codes are used exclusively at your telephone.
To make a call using a speed dial code:
1. Press ≤‚.
2. Enter the three-digit code for the number.
To program user speed dial numbers:
1. Press ≤•›.
2. Enter a three-digit code from 256 to 279.
3. Specify an external line by pressing a line or intercom button or by
entering a line pool. If you do not specify the line, the system
automatically chooses a line for the call.
4. Dial the telephone number you want to program (up to 24 digits).
5. Press ≥.
6. Record the code and the number you have just programmed.
You cannot program user speed dial numbers while someone else is
programming your system. Codes you enter can be overridden by
your system administrator.
Static time
and date ≤°‚fl Cancel ≤£°‚fl
Change the first line of the display to the current time and date.
^(Automatic change for Daylight Savings Time is not supported)
Time & date ≤°‚‹
Briefly display the time and date while you are on a call.
Transfer ≤‡‚
Send a call to another telephone within your system, or to an external
telephone. You may not be able to transfer a call on an external line to
an external telephone, depending on the capabilities of the lines.
1. Make or answer a call.
2. Press ≤‡‚.
3. Call the person you want to transfer the call to.
4. Stay on the line if you wish to speak to the person first.
5. Press ® to complete the transfer.
If an external call is transferred to a busy internal or network extension,
or is not answered after a few rings, the call automatically rings you
back.