Nortel Networks 6300 User Manual
Remote annex 6300
Advertising
Table of contents
Document Outline
- 1 All direct connections to ISDN lines must be mad...
- 2 Before connecting your unit, you must inform the...
- Port ID
- REN/SOC
- FIC
- USOC
- About this Guide
- Printing Conventions
- Related Documents
- Bay Networks Customer Service
- Bay Networks Information Services
- Remote Network Access
- Remote Annex 6300 Description
- Main Logic Board
- Modem Carrier Card
- Firmware and Software
- Front Panel
- Rear Panel
- Physical Characteristics
- Before you Begin
- Installing the Remote Annex 6300 in a Rack (Option...
- Connecting a LAN Using Ethernet
- Connecting a Console Terminal
- Connecting the PRI ISDN Interface
- Powering Up and Testing the Remote Annex 6300
- Installing the Operational Software and Loading th...
- Auto-initializing the Remote Annex 6300
- Self-booting the Remote Annex 6300
- Invoking the Console Monitor
- Command Descriptions
- Table 3-1 . ROM Monitor Commands
- Command
- Description
- Use
- Command
- Description
- Use
- Command
- Description
- Use
- addr
- boot
- config
- console-baud
- erase
- help
- image
- ipx
- lat_key
- mop
- net
- option_key
- ping
- ports
- sequence
- stats
- Power-up and Boot Procedures
- Normal Mode Remote Annex 6300 Diagnostics
- Activity N1: Testing LEDs
- Activity N2: Testing the Hardware
- Activity NE2: Hardware Failure
- Activity NE5: Booted Wrong Image
- Activity T1: Testing LEDs
- Activity T2: Testing the Hardware
- Activity T3: At the Monitor Prompt
- Activity TE2: Hardware Failure
- Activity TE7: Booted Wrong Image
- Boot Failures
- Remote Annex 6300 Dumps
- Console Port
- 10Base2 Ethernet Port
- 10Base5 Ethernet Port
- 10BaseT Ethernet Port
- PRI ISDN Interface
- Loopback Connectors
- Contents of the Kit
- Disassembly Instructions
- Installation Instructions
- 1 Plug each 34P ribbon cable into the main logic b...
- 2 Plug the power extension cable into the MLB (Con...
- 3 Lower the modem carrier card into the chassis an...
- 4 Plug each 34P ribbon cable from the MLB into its...
- 5 Plug the power extension cable from the MLB into...
- Figure C-2 . Adding Modem Carrier Card to the Remo...
- Assembly Instructions
- Power-up and Test
- Contents of the Kit
- Disassembly Instructions
- Installation Instructions
- 1 Find the next available location on the modem ca...
- 2 Lower the modem card onto the modem carrier card...
- 3 Carefully press the modem card into the card con...
- 4 Push one corner of the modem card down onto the ...
- 5 Repeat the previous procedure with the other thr...
- Figure D-2 . Adding Modem Cards to the Remote Anne...
- Assembly Instructions
- Power-up and Test
- Removing Quad Modem Cards
- Table D-1 . Modem Card/S1 DIP Switch Section Assig...
- Modem Card Location
- DIP Switch Section (S1)
- A
- B
- C
- D
- E
- F
- H
- I
- L
- M
- N
- O
- P
- Q
- R
- S
- T
- U
- W
- X
- Index