Nortel Networks 6300 - Manual (Page 58)

Remote Annex 6300 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 6300
2-22
To boot your Remote Annex 6300 from Flash ROM.
1 Enter the ROM Monitor prompt from the console.
2 Set the Internet address to a valid IP address and the subnet mask to
a valid mask using the addr command.
3 Set the interface sequence to self using the sequence command.
4 Boot the unit.
Invoking the Console Monitor
After the image boots, you can invoke a Console Monitor by pressing
on the console. At the Console Monitor prompt, entering help
or ? displays the available options:
❑ dump (from the Remote Annex to the host and reboots).
❑ help or ? (displays the available options).
❑ info (displays configuration information for the Remote
Annex).
❑ leds (displays the current front panel LED status).
❑ quit (exit the Console Monitor, e.g., quiet the console).
❑ reboot filename (reboots the Remote Annex).
❑ rom (returns the Remote Annex to the ROM Monitor).
❑ syslog (displays syslog messages).
Return