Nortel Networks 6300 - Manual (Page 93)

4-5 Remote Annex 6300 Hardware Installation Guide
Chapter 4 Troubleshooting Procedures
Normal Mode Remote Annex 6300 Diagnostics
Following power-up or reset, the Remote Annex 6300 enters Normal
mode. The following subsections describe both the possible error and
error-free conditions that can occur during power-up and booting in
Normal mode.
Normal Mode Error-free Sequence
Table 4-2 summarizes the LED display states during error-free
power-up in Normal mode. The following subsections describe
these states.
Table 4-2. Normal Mode Error-free LED States
Key:
●
On continuously.
✕ Off.
■ Flashing irregularly.
◆ Flashing regularly (about 1Hz).
Activity N1: Testing
LEDs All front panel LEDs light for a few seconds, then all but the Ethernet
LED (segment LED) turn off, confirming that all LEDs are operational.
Activity
STAT
Green
ATTN
Amber
TRAF
Green
N1: LEDs OK ● ● ●
N2: Hardware OK ● ✕ ●