Nortel Networks 6300 - Manual (Page 44)

Remote Annex 6300 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 6300
2-8
1 Verify that both sides of the T-connector are connected to the Thin
Ethernet cable.
If the Remote Annex 6300 is the last device on the Thin Ethernet
segment, make sure that one side of the T-connector is connected
to the cable and the other side is connected to a network
terminator.
2 Plug the T-connector on the Thin Ethernet cable (RG-58 coaxial
cable) into the 10Base2 Ethernet connector located on the rear
panel of the Remote Annex 6300.
3 Twist the sleeve on the T-connector clockwise to lock the connection
in place.
Figure 2-6. Connecting Thin Ethernet Cable