Nortel Networks 6300 - Manual (Page 95)

4-7 Remote Annex 6300 Hardware Installation Guide
Chapter 4 Troubleshooting Procedures
Activity NE5:
Booted Wrong
Image The Remote Annex 6300 loaded the wrong image. Press the
button for 3 seconds to reset the device. Following is a list of ways to
prevent this problem in the future:
❑ Make sure that you configure the Remote Annex 6300 with
the appropriate image.
❑ Be sure that the image you are booting has the right name.
Don’t rename the image file unless you are making a copy
for safe keeping.
❑ If you used an na, admin, or cli boot command, specify the
correct image and a valid filename.
If you do not know why the Remote Annex 6300 booted the wrong
image, enter Setup mode and issue an image -d command. The
command display will list the image file the Remote Annex 6300 is
trying to load.
Setup Mode
Enter Setup mode by pressing the button located on the Remote
Annex 6300 front panel. Press this button within 30 seconds of
resetting or powering up the device.
Setup Mode Error-free Sequence
Table 4-4 summarizes the LED sequences that display in Test mode
during an error-free start-up. A description of each sequence follows
Table 4-4.
Reset
Reset