Nortel Networks 6300 - Manual (Page 37)

2-1 Remote Annex 6300 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 6300
T
his chapter describes how to install your Remote Annex 6300
hardware and connect it to your Ethernet network. Setting up the
Remote Annex 6300 consists of:
❑ Installing the Remote Annex 6300 in a Rack (Optional)
❑ Connecting a LAN
❑ Connecting a Console Terminal
❑ Connecting a PRI ISDN Interface
❑ Powering Up and Testing the Remote Annex 6300
❑ Installing the Software and Loading the Operational Image
❑ Auto-initializing the ROMs
❑ Self-booting the Remote Annex 6300
❑ Invoking a Console Monitor
Before you Begin
The Remote Annex 6300’s software and operational image can be
installed on two different devices.
Table 2-1 outlines the different
configurations the Remote Annex 6300 supports.
Table 2-1. Remote Annex 6300 Configuration Options
Device on which the Operational
Software and Image is installed
Remote Annex
6300 Must be
Connected to
the Network
Input Device used to
Enter Installation
Parameters
UNIX Load Host Yes Console
Remote Annex 6300 Flash ROM
(Self-booting) No Console