Nortel Networks 6300 - Manual (Page 53)

2-17 Remote Annex 6300 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 6300
4 Record the Remote Annex’s Ethernet address for future reference.
At the monitor prompt, type addr - d and press . The screen
display looks similar to this:
Installing the Operational Software and Loading the
Image
Use this section if you have successfully connected the Remote Annex
6300 to your LAN.
This section describes:
❑ How to install the Remote Annex 6300’s operational software
and image on a device that resides on a network accessible
to the Remote Annex 6300.
❑ How to download the operational image from the device to
the Remote Annex 6300.
Return
monitor:: addr -d
Ethernet address (hex): 00-80-2D-XX-XX-XX
Internet address: <uninitialized>
Subnet mask: 255.255.0.0
Broadcast address: 0.0.0.0
Preferred Load Host address: <any host>
Preferred Dump Host address: 0.0.0.0
Load/Dump Gateway address: 0.0.0.0
Type of IP packet encapsulation: <ethernet>
Load Broadcast: Y