Nortel Networks 6300 - Manual (Page 100)

Remote Annex 6300 Hardware Installation Guide
Chapter 4 Troubleshooting Procedures
4-12
Table 4-6. Errors from Last ERPC Layer Invocation
Table 4-7. Errors from Last Read Request
Error Description
H/W errors The Remote Annex 6300 sensed a hardware error during
message transmission or reception. This error indicates a
fault with the Remote Annex 6300 LAN interface. Use the
net
command to isolate the problem (see page 3-23).
Msgs from
wrong host The Remote Annex 6300 received a message from an
incorrect host. This indicates that the Remote Annex 6300
received, and ignored, an unsolicited packet.
Rsp T/O’s The Remote Annex 6300 never received a correctly
formatted response from the correct host, or any
response from any load server hosts.
Msgs of
wrong type The correct host sent a message to the Remote Annex
6300, but the message was not a correctly formatted
response to the transmitted request.
Error Description
Msgs with wrong
size The correct host responded to the Read Request,
but the data size is incorrect.
ERPC layer errors See Table 4-6 .
Aborts rx’d The host’s BFS transmitted an abort in response to
the Remote Annex 6300’s Read Request. Run
erpcd –D
on the host to obtain more information.