Nortel Networks 6300 - Manual (Page 101)

4-13 Remote Annex 6300 Hardware Installation Guide
Chapter 4 Troubleshooting Procedures
Table 4-8. Errors from Last Open Request
Correcting Remote Annex 6300 Parameters
The following parameters must accurately reflect both the Remote
Annex 6300 and the network environment in which it operates.
Verify the Remote Annex 6300’s IP address using the addr command.
If your network configuration does not support the factory defaults,
verify the following parameters using the addr command:
❑ The broadcast address.
❑ The subnet mask.
❑ The load/dump gateway address (which must be specified
if the preferred load server host is located on another
network or subnet).
Error Description
ARP errors Address Resolution Protocol (ARP) errors indicate
that the Remote Annex 6300 is configured to boot
from a specified host, but the host would not transmit
its Ethernet address to the Remote Annex 6300.
Possibly, the Remote Annex 6300 configuration
includes the wrong IP encapsulation.
ERPC layer
errors See Table 4-6 .
Aborts rx’d The host’s BFS transmitted an abort in response to the
Remote Annex 6300’s Open Request. This often
means that the requested file does not exist on that
server. Run erpcd –D on the host to obtain more
information.