Nortel Networks 6300 - Manual (Page 48)

Remote Annex 6300 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 6300
2-12
2 Plug the 8-pin connector into the console port located on the back
panel of the Remote Annex 6300 (
Figure 2-10 ).
When the connector clicks into place, the connection is secure.
Appendix A describes the console port’s signal/pin allocation.
Figure 2-10. Connecting a Console Terminal
3 Turn on the console terminal and set the terminal to 9600 baud, eight
data bits, no parity, one stop bit, and XON/XOFF flow control.
The ROM Monitor assumes that this terminal is CRT-based and
displays the backspace (BS) character accordingly. See
Chapter 3
for information on invoking the ROM monitor.