Attaching the mounting bracket to the remote annex, 1 remove the mounting bracket from its package, 2 remove three screws from the front of the cover – Nortel Networks 6300 User Manual
Page 39: 3 install front mounting bracket to the device usi, 4 tighten the screws to secure the bracket to the, Figure 2-1 . attaching the mounting bracket to the
Advertising
2-3
Remote Annex 6300 Hardware Installation Guide
Chapter 2
Installing the Remote Annex 6300
Attaching the Mounting Bracket to the Remote Annex 6300
Attach the front mounting bracket to the Remote Annex 6300 as
follows:
1
Remove the mounting bracket from its package.
2
Remove three screws from the front of the cover on each side of the
Remote Annex 6300, as shown in
. Save these screws; you
will need them later to install the front mounting bracket.
3
Install front mounting bracket to the device using the six screws
previously removed.
4
Tighten the screws to secure the bracket to the device.
Figure 2-1. Attaching the Mounting Bracket to the Remote Annex 6300
Screws
(3 places each side)
Advertising