Nortel Networks 6300 - Manual (Page 51)

2-15 Remote Annex 6300 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 6300
The Remote Annex 6300 now runs its ROM-resident power-up
diagnostics. The LEDs light and then turn off, except for some
status LEDs.
The ROM-resident, power-up diagnostics take 2 to
3 minutes to complete.
If the diagnostics complete successfully, the Remote Annex 6300
either enters Setup Mode and waits for configuration data to be
entered or boots its operational image from Flash.
Figure 2-13. Connecting the Power Cord
You can enter configuration information through a terminal
connected to the console port. The ROM Monitor prompt
(
monitor:: ) appears on the terminal.