Nortel Networks 6300 - Manual (Page 61)

3-3 Remote Annex 6300 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
Table 3-1. ROM Monitor Commands (continued)
(continued on next page)
Command Description Use
boot [-l] [<file>] Erases the existing
Flash memory and
copies a new image to
Flash. Upgrading or
replacing the Flash
image.
config Displays the current
hardware
configuration and
revision levels. Identifying your
hardware, memory,
and ROM versions.
console-baud Changes the console
port’s baud rate. Configuring the
console port for remote
maintenance.
erase Erases non-volatile
memory. Loading a new image
and need to erase the
old image.
help Displays the list of
ROM Monitor
commands. Referencing the ROM
monitor commands.
image [-d | <file>] Displays and/or sets
the load image and
tftp
load dump names.
Loading an image that
differs from the
default.
ipx [-d]
(not supported in
this release)
Displays and sets
EEPROM values
relevant to Novell/IPX
network addressing,
including the IPX
load/dump file server. Changing Novell/IPX
configuration
parameters. This
command is not used
for this configuration
of the Remote Annex
6300.
lat_key [-d] Sets the LAT key. Connecting to a DEC
VMS host.