Nuvo NV-E6XS - Manual (Page 5)

LINE OUT
L
LINE OUT / SPEAKER
LINE OUT LINE OUT LINE OUT LINE OUT LINE OUT
ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5 ZONE 6
20W/8 OHM X2 20W/8 OHM X2 20W/8 OHM X2 20W/8 OHM X2 20W/8 OHM X2 20W/8 OHM X2
R L R L R L R L R L R LEFT
- + RIGHT - +
LEFT
- + RIGHT - +
LEFT
- + RIGHT - +
LEFT
- + RIGHT - +
LEFT
- + RIGHT - +
LEFT
- + RIGHT - +
0215
IR EMITTER OUTPUTS
+12V OUTPUT PULSE
1 2 3 4 5 6 SUM
AUDIO OUTPUT
CONNECT TO NV-E6X
ODD NUMBERED OUTPUTS ARE IDENTICAL (TIED TOGETHER)
EVEN NUMBERED OUTPUTS ARE IDENTICAL (TIED TOGETHER)
REFER TO MANUAL
0 1 2 3
DIAGNOSTIC CONTROL
-INPUT- -OUTPUT-
MUTE UNIT ON
+12V G N.O. G
1 2 3 4 5 6
INPUT SOURCES
L
R
DIGITAL OUTPUT
CONNECT TO
NV-E6X
NETWORK
CONNECT TO
NV-EZP
1 2 3 4 5 6 7 8 9 10
120V 60Hz 300W
MODEL NV-E6M
SIX SOURCE SIX ZONE
AUDIO DISTRIBUTION SYSTEM
KUSTOM INC. CINCINNATI, OH USA
Page 3
The E Series amplifier accepts up to six audio sources. These can
accept any audio component capable of supplying a line level signal.
Preamp lineouts for each zone allow you to easily use an additional
amplifier to power additional speakers in a zone. Only use one pair
of 8-ohm speakers per zone.
Individual stereo speaker outputs provide 20 watts output per channel
to each zone.
This multi-pin connection is used to transfer the audio information from
the E Series main amplifier to the expander amplifier. This output is
used to expand the system to twelve zones.
These outputs transfer IR signals from the zones to your source
components. They are routed odd and even so that when source
1, 3, or 5 is selected at any of the keypads, the IR outputs 1, 3, and 5
all flash IR commands. Similarly, when source 2, 4, or 6 is
selected at any of the keypads, the IR outputs 2, 4, and 6 all flash.
The “Sum” output always flashes IR commands regardless of the
source selected.
These four LEDs indicate the operation of the system’s MPU. They
also indicate correct communication through the system.
A single Cat-5 wire terminated with an RJ45 connector carries all the
information from the individual zones to the main amplifier.
This multi-pin connection transfers all the digital information from the
main amplifier to the expander amplifier. This output is used to expand
the system from six to twelve zones.
This input temporarily mutes the system when the pins are shorted by
a dry contact closure.
Detachable power cord connects the system to an external AC power
supply.
Audio Source Inputs:
Preamp LINEOUTS:
Speaker Outputs:
Audiolink:
Routed IR Outputs:
Diagnostic LEDs:
RJ45 Input:
Datalink:
Mute Input:
AC:
2
1
3
8
7
6
5
4
10
9
E Series Amplifier Back Panel