NordicTrack E 200 NTBE1506.0 User Manual
Page 6
6
1.
Attach the Small Stabilizer (2) to the Frame (1)
with two M10 x 90mm Bolts (18), two M10
Washers (23), and two M10 Nylon
Locknuts (24).
1
Before beginning assembly, make sure
that you understand all the information
on page 5.
24
24
18
1
2
23
23
2.
Orient the Large Stabilizer (3) so that the high
side of the mounting bracket is on the side
shown. Attach the Large Stabilizer to the Frame
(1) with two M10 x 15mm Screws (21) and two
M10 Washers (23).
21
1
3
High side of
mounting bracket
2
3.
Orient the Deck (4) as shown, and press it onto
the Frame (1).
Next, attach the Seat Frame (5) to the Frame
(1) with two M10 x 65mm Screws (20) and two
M10 Washers (23).
Hand tighten the Backrest Knob (11) into the
Seat Frame (5). Next, pull the Backrest Knob
and use an adjustable wrench to fully tighten
the shaft of the Backrest Knob into the Seat
Frame. Then, release the Backrest Knob.
4.
See the inset drawing. Locate the bracket weld-
ed to the back of the Backrest Frame (6).
Attach the Backrest Bracket (7) to the bracket
on the Backrest Frame (6) with two M10 x
25mm Bolts (17), two M10 Washers (23), and
two M10 Nylon Locknuts (24).
3
1
5
20
11
4
17
7
6
23
23
23
24
23
4
Bracket
6