Numark Industries TT200 - Manual (Page 12)

Problem Cause? Solution
Turntable does not turn on. Disconnected Power Cord? Connect Power Cord.
The sound level is very low. The Turntable is not connected to a
device with a PHONO preamp.
Connect the device to a preamp DJ
mixer or an AV receiver that has an
input labeled PHONO, not AUX or
LINE.
The sound is on one side only. The Cartridge is not properly wired.
The Stylus is worn out.
The RCA audio cord is
disconnected.
The RCA audio cord is damaged.
Reconnect the wires from the
headshell to the cartridge. See the
"Cartridge Setup" section for more
detail.
Replace the stylus on the cartridge.
Replacement styli are available
from most Numark Retailers.
Properly secure the RCA cable to
the preamp device and the bottom
of the turntable. See the "Cable
Connections" section for more
detail.
If the RCA cord is frequently
connected and disconnected, it
may have become damaged and
needs to be replaced.
The output sound is very distorted. The Cartridge is not properly wired.
The Stylus is worn out.
Reconnect the wires from the
headshell to the cartridge. See the
"Cartridge Setup" section for more
detail.
Replace the stylus on the cartridge.
Replacement styli are available
from most Numark Retailers.
The Target Light glows
inconsistently, flickers, or doesn't
work at all.
The Target Light Lamp is burning or
burned out.
Replace the entire target light with
a compatible Numark part.
The Output sound exhibits
excessive hum or buzzing.
The Turntable Grounding wires are
not connected.
Connect the Turntable Ground
wires to their respective Grounding
Lug on all equipment (mixer, etc.)
The turntable skips like crazy. The Turntable is on an unstable
surface.
The Tone Arm is not balanced
properly.
The Stylus is worn out.
Excessive force is being applied
directly down on the platter.
The record is warped.
Follow the guidelines for installation
in the "Setup & Installation"
Section.
Follow the guidelines for optimum
setup in the "Tone Arm Setup"
Section.
Replace the stylus on the cartridge.
Replacement styli are available
from most Numark Retailers.
Reread the "Operation" section of
this manual.
Buy new records.
NOTE:
Static electricity and/or other external interference may cause this unit to malfunction. To reset the unit to its normal
condition, turn the power off and then on again. If the problem continues to persist, refer to the connected component's
troubleshooting guides. If the problem is not resolved after checking these items, contact the nearest authorized Numark
dealer.
TROUBLE SHOOTING PAGE 12