Numark Industries TT200 - Manual (Page 7)

PAGE 7 CONTROLS
CONTROLS
General Controls
1. Power Button
Pushing this button down turns on the turntable. It illuminates red when the turntable is switched on.
2. Start/Stop Buttons
These buttons start and stop the turntable motor. Both buttons have the same function.
3. Platter
This turntable has a special edge design that has been optimized for "dragged" platter slow downs.
4. Reverse Button
Pushing this button down reverses the rotation direction of the turntable platter.
5. Pitch Slider
This slide control allows the pitch to be increased or decreased by 10%. In the center position the pitch is
at 0%. When moved away from the center and towards the tone arm decreases the pitch (slows down the
platter) and moving the pitch slider away from the tone arm increase the pitch (speeds up the platter)
6. Target Light
This aluminum target light can be removed and rotated depending on the head shell position and the
amount of light required on the vinyl record surface.
7. Target Light Power Jack
This RCA Jack supplies power to the Target Light (sold seperately). IT HAS NO AUDIO FUNCTION-DO NOT
CONNECT AUDIO CORDS TO THIS POWER JACK.
8. 33 and 45 RPM Buttons
These buttons control the RPM of the turntable platter. A red LED indicates which RPM mode has been
selected. When both the 33 and 45 RPM buttons are pressed, both LED's illuminate indicate 78 RPM mode
has been engaged.
9. Quartz Button
The Pitch LED illuminates green when the pitch is set at 0% or the Quartz Button is engaged. When the
pitch slider is moved away from zero, the LED illuminates red indicating the pitch is no longer at 0%.
3 1
2 4
5
6 7 8 9