Siemens LC 957 AA 70 - Manual (Page 30)

30
Installation
0 7. Remove the extractor hood. Drill the
4 lower 8 mm ø fixing holes and press
in the wall plugs flush with the wall.
0 8. Attach the extractor hood and screw
into position with the remaining
4 screws.
0 9. Stick protective film over the holes of
the 2 lower mounting bolts in the
protective grid.
14. Insert the complete flue duct at an
angle and swivel to the rear.
15. Carefully pull the upper flue duct
upwards and screw the sides to the
fixing bracket with 2 screws.
1.
2.
3.
16. Unscrew the trans-
portation protec-
tion devices on
the left and
right. The
transportation
protection devices
must be handed to the
customer for safe-keeping.
ṇ
After removing the transportation
protection devices, follow the safety
instructions and the cleaning and care
instructions regarding the dangers of
being crushed.
17. Insert the grease filter (refer to
Operating Instructions).
ṇ
Re-insert air conduction plate
(see Activated-carbon filter).
10. Connect up the air outlet pipe.
11. Connect the hood to the electricity
supply.
12. Carefully remove the protective foil.
ṇ
Avoid damage to the sensitive
surface.
13. Insert the upper flue duct (slots
downwards) into the lower flue duct.
ṇ
Protect the cover panels from
scratches, for example by laying the
template used for marking the wall over
the top edge of the lower section.