Reference, Troubleshooting – NAD C245BEE User Manual

Page 10

Advertising
background image

condition

poSSible cauSeS

poSSible SolutionS

No power.

The power cord is disconnected.

•

Plug the power cord into the wall outlet

securely.

•

C 245BEE at standby mode.

•

Press front panel STANDBY button to switch

ON the C 245BEE.

•

Rear panel POWER switch not at ON setting.

•

Set the rear panel POWER switch to ON

setting.

•

C BEE always at standby mode;

cannot be switched ON using the

front panel STANDBY button.

+12V TRIGGER IN/INPUT SENSE switch set to “AUTO”

position and a jack is plugged-in at +12V Trigger IN

socket or an input signal is applied at the rear panel

CHANNEL A IN or CHANNEL B IN sockets.

•

Slide the +12V TRIGGER IN/INPUT SENSE

switch to “OFF” position and unplug the jack

at the +12V Trigger IN socket or remove

the input signal applied at the rear panel

CHANNEL A IN or CHANNEL B IN sockets.

•

The C 245BEE is not powered OFF using the front

panel STANDBY button.

•

Power ON the C 245BEE in the same manner

by which it was deactivated.

•

No sound.

Power AC lead unplugged or power not switched ON.

•

Check if AC lead is plugged-in and POWER

switched ON (along with the corresponding

ATO logic configuration).

•

Front panel CHANNEL A or CHANNEL B button is not

activated.

•

Press CHANNEL A or CHANNEL B to select

active input signal available at the rear panel

CHANNEL A IN or CHANNEL B IN sockets.

•

No input signal applied through the rear panel

CHANNEL A IN or CHANNEL B IN sockets.

•

Ensure that there is active input signal

applied through the rear panel CHANNEL A

IN or CHANNEL B IN sockets.

•

No sound one channel.

Speaker not properly connected or damaged.

•

Check connections and speakers.

•

Input lead disconnected or damaged.

•

Check leads and connections.

•

Weak bass/diffused stereo image.

Speakers wired out of phase.

•

Check connections to all speakers in the

system.

•

STANDBY LED stays red upon

setting POWER switch to ON.

There is short circuit in the speaker cabling.

•

Switch C 245BEE OFF and check speaker

cable connections for both speaker terminals

at the rear panel.

•

REFERENCE

troubleShooting

10

EN

G

LIS

H

FR

A

N

Ç

A

IS

ES

PA

Ñ

O

L

IT

A

LIA

N

O

D

EU

TS

CH

N

ED

ER

LA

N

D

S

SV

EN

SK

A

РУ

СС

К

И

Й

Advertising